Universal Devices ISY-994i Series Guía de usuario descargar pdf (Pagina 85)

the light starts flashing.

To EXIT linking mode, either wait for the RemoteLinc to time out and the LED to stop

flashing (4 minutes), or simply hit the BRIGHT or DIM button. DO NOT hit one of the 6

rocker buttons.

RemoteLincs show up as a multiple nodes on the ISY (one node per button).

Thermostat Adapter

Older INSTEON Thermostat Adapters cannot act as controllers, thus they do not notify

the ISY of any state changes. To get the most current information from your thermostat,

we recommend using an ISY Program to poll the device periodically. See Appendix G:

Sample ISY Programs.

Newer Thermostat Adapters (V2) do notify the ISY of state changes, so a poll Program

will not be necessary.

TriggerLinc

TriggerLincs are RF devices, thus require the installation of an INSTEON RF receiver

(such as an INSTEON AccessPoint).

The TriggerLinc cannot be linked using Auto Discover. To link a TriggerLinc to the ISY,

please choose the LINK MANAGEMENT pulldown, then NEW INSTEON DEVICE.

Enter the device address manually (found inside the battery compartment), then select

the “2421 TriggerLinc” from the Device Type list.

Since the TriggerLinc is a battery-saving RF device, you must put the device into linking

mode to add it to the ISY (and make any changes to the device, such as

adding/removing from scenes). Please follow the on-screen instructions to put the

TriggerLinc into linking mode when prompted (hold SET button for 5 seconds).

Once added to the ISY, the TriggerLinc will show up as 2 nodes. The secondary node

is only used when the TriggerLinc is in “Multi-Scene” mode.

When in Normal mode, the TriggerLinc will send an ON command to the primary node

when the sensor is open (magnet pulled away) and an OFF command when the sensor

is closed (magnet close to sensor).

When in Multi-Scene mode, the TriggerLinc will send an ON command to the first node

when the sensor is open, and an ON command to the second node when the sensor is

closed. It will NOT send an OFF command to either node when in Multi-Scene mode.

1 2 ... 80 81 82 83 84 85 86 87 88 89

Sin comentarios

Universal Devices ISY-994i Series Guía de usuario Pagina 85